qnap surveillance station motion detection

However, you can just go back and rename it again from within the camera web interface afterwards.įollowing the guide in the synology forums for making logitech alert cameras work with surveillance station natively, i have been able to copy one of the other hikvision profiles to work with my hikvision cameras natively, i've had success with both cameras from the lorex bundle on sale now, and the swann full size bullet. There is one minor downside, and that is that SS will reconfigure the camera device name to 'SynoSurveillance' when you configure it from SS. While I haven't used this setup for more than a couple of hours yet, I have a good feeling that it is the better method. This drops the CPU usage by a great deal, and you configure the motion detection sensitivity and masking area in the camera (which has a better method than the stupid way it is done in SS). Then, almost by accident, I discovered that if I configure SS to talk to the cameras in PSIA-mode instead of ONVIF, it is actually possible to use in-camera motion detection in SS. This causes the NAS to spend quite a lot of CPU on motion detection, and also the motion detection options in SS leaves a lot to be desired. The downside is that you have to use the motion detection in SS, you can't use in-camera motion detection. There is no native support for these cameras, so I have been using them in Onvif mode, which works. SS has a lot more flaws and quirks than I care for, but as long as I already have the NAS, it is the easy route.

I'm using the Hikvision 3MP bullets and Synology Surveillance Station on my NAS. I'm just posting this in the hope that it might be useful for others:

Qnap surveillance station motion detection